Sharp Industries 220V 9" x 49” Digital Variable Speed 2 Axes CNC Vertical Knee Mill LMV-49/DVS/MP-2 G2

Description

This is a simple, easy to use 2 axes CNC control vertical mill. Ball screws and servo drives are installed for longitudinal and cross travel. 3 axes Digital Readout System are installed on the table, saddle, and quill. The Millpwr G2 CNC has G code and conversational type programming. The CNC system is built on the top quality SHARP vertical mills frame.

Standard Features

• 9 x 49” table, 11 x 31 x 5” travel, Digital Variable Speed
• AcuRite Millpwr G2 CNC 2 axes control (Longitudinal, Cross)
• G code and conversational type programming
• 2 axes precision ball screws
• Safety handwheels
• Auto lube system
• 3 axes Digital Readout System (table, saddle, quill)
• Digital servo drive system (2 axes) (table, saddle)
• Hard chromed ways
• Meehanite castings
• Roller bearing support bottom of motor shaft
• Abec-7 super precision angular contact bearings
• Front and rear way covers           
• Models with DVS head for 220V works on single phase power

Specifications

• Table Size: 9” x 49”
• T-Slots (No., Size, Pitch): 3”, 5/8”, 2.5”
• Table Travel: X Longitudinal: 31”
• Table Travel: Y Cross: 11”
• Quill Travel: Z Vertical: 5”
• Ram Travel: 12”
• Knee Travel: Vertical: 16”
• Spindle Center to Column: 6.75” - 18.5”
• Spindle Nose to Table Top: 2.125” - 18”
• Spindle Nose Taper: R-8
• Spindle Variable Speed Range: 60 - 4500 rpm
• Spindle Motor(220V/440V): 3 HP
• Quill Feed (Inch/Rev)(3 Speed): .0015”, .003”, .006”
• Quill Diameter: 3.375”
• Head Swivel Angle: 360°
• Head Tilt Angle (L/R): 45°
• Head Tilt Angle (Up/Down): 45°
• Floor Area (W x D x H): 7’ x 6.6’ x 6.7’
• Approximate Weight: 2,500 lbs
• Power Consumption (220V): 3 KVA / 15 amps
• Power Consumption (440V): 3 KVA/ 7.5 amps

Available Options & Accessories

• 440V available with the purchase of an additional transformer
• Acu-Rite electrical edge finder
• 6” “Kurt” Vise with Swivel Base
• Drill chuck
• Sharp Power Kneel
• Coolant System with Chip Pan at Base
• Power Draw Bar                        
• R-8 Collet (Set of 11) – 1/8” – 3/4” by 1/16”
• Clamping Kit (52 pcs/steel rack)
• Halogen Work light
• Riser block 6
• 4th axes Digital Readout System (on knee)