Injection Molding

  • Generator power consumption: 3.5 kVA
  • Roughness: < 0.3 µm Ra
  • Travel X-axis: 9.8”
  • Travel Y-axis: 8”
  • Generator power consumption: 7.5 kVA
  • Roughness: < 0.3 µm Ra
  • Travel X-axis: 17.7”
  • Travel Y-axis: 14”
  • Generator power consumption: 9 kVA
  • Roughness: < 0.3 µm Ra
  • Travel X-axis: 27.6”
  • Travel Y-axis: 24”
  • max 33cc / min 5cc
  • max gallons 15.7 per min / min gallons 0.26 per min
  • Viton seals used through out
  • User friendly
  • 11.5cc max / 1.8cc min capacity
  • Inlet port 3/4" NPTF, Outlet port 1/2" NPTF
  • Max gallons per/min 5.4 / min gallons per/min .09
  • max speed rev/min 1800 / min speed rev/min 200
  • Pump can be adjusted accurately from 0 - 6.0 cm3/rev
  • Can be applied with TDI, MDI, and TDI/MDI mixes and polyether and polyester resins.
  • Loose port plate
  • Control: FA, MB, MD
  • 10mm
  •  Orifice sizes: .05MM through 4.2MM.  Your specific sizes supplied with mix head
  • Chemical & Hydraulic ports
  • 3rd Stream color port for dosing system or recirculation system 
  • Long wearing Clean-out and pour rods
  • adjustable clean-out stroke for better mix control
  • 2 proximity switches - PNP 3-wired D.C. current, normally open
  • Orifice sizes: .05MM through 4.2MM.  Your specific sizes supplied with mix head
  • Orfice sizes: 0.5MM through 4.2MM
  • Chemical and hydraulic ports: SAE straight thread O ring fittings with JCI 37° flared ends.  Your specific sizes supplied with mix head
  • Long-wearing clean out and pour rods
  • Third stream color port