Carell Industrial MRM-S Series 5’ x 3/16” 220V Three Phase 3-Roll Powered Initial Pinch Plate Roll 1550x150

Description

Carell’s MRM-S series model 1550x150 unit is a 5’ x 3/16”, 3 roll, single initial pinch plate bending machine with powered adjustment of lateral bending roll and powered rotation of upper and lower pinch rolls using high efficiency motor/reduction units. 

Features

• Both upper roll and central pinch rolls driven by electric motor and oil bath speed reducer through NiCrMo solid stock gears
• Base in steel, electro-welded and stress relieved
• Lateral roll, idle, and moving on roller bearings
• Pinch roll pinch pressure adjustable by precision worm gear movement with single manual hand wheel crank
• Front quick release top roll with rotation lock out safety switch
• Lateral roll movement up/down powered via electric motor and heavy duty worm gear drive for precise positioning and maximum power
• Lateral bending roll and pinch roll incline for cone working
• Push button controls, low voltage 24VAC for safety
• Multi point safety system including circumferential trip wire
• Instruction manual 

Standard Equipment

• Cone rolling attachment
• Induction hardened rolls
• LED readout on bending roll
• Polished roll finish to remove heat treatment residues
• Powered pinch roll adjustment up/down
• Add on foot pedals w/trailing lead & Estop 

Specifications

• Useful length: 5’ (total roll 62”)
• Bending maximum: ¼” total rolling capacity
• Pre-bending: 3/16”
• Min ID with thin sheet equal to 1.4 x TR OD
• Top & Pinch Roll OD: 5.9” (150mm)
• Lateral bending roll OD: 5.9”
• Production velocity: 12 fpm
• Installed power: 5.5 HP
• Electrical Requirements: 220V Three Phase 60Hz
• Machine Dims: 128” x 28” x 42”
• Approx Weight: 3,740 lbs 

Optional Add-Ons 

• Shaft extensions for section bending rolls
• Section bending dies
• LED readout on pinch roll