SCM Group 37” Automatic Wide Belt Sander with Combi Head DMC SD 10 CS 95

DMC SD 10 Advantages

• Automatic belt centering
• Automatic feed conveyor centering
• Motorized belt conveyor positioning with digital readout of working thickness
• Electronic positioning device for a precise and fast working table opening
• “Hand-safety” device to offer the best and safest working conditions
• In-feed idle roller conveyor permits to resist heavy working loads
• The out-feed pressure roller allows a uniform and intense pressure in calibrating with high removal and sanding of short and narrow pieces
• Rapid and precise locking system of the working unit
• Pre-loading indicators grant a better positioning of the combined unit, thus obtaining an impeccable finishing
• Exhaust hood for the dust dispersion control during processing

Features

• Rubber coated pressing rollers before and after sanding unit
• Additional flexible hold-down plate before sanding unit.
• .7 HP 2 speed feed unit. Feed speeds set at 15 and 30 feet per minute
• Electronic digital thickness readout of work table position
• Electronic positioning of the work table
• Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
• Accurate and reliable electronic tracking of abrasive belt
• Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt
• Front and rear emergency stop buttons
• Automatic emergency stop of machine for:
  • sanding belt breaking, tensioning, over tracking
  • opening of the access door to the operating groups
  • absence of compressed air
  • overload on main motors
• Amperage meter for main motors allows maximum utilization of available horsepower
• Main disconnect switch with the ability to be locked out by padlock
• 50 shore, negative profile (waffle style) rubber feed mat
• Infeed and Outfeed tables with 2 rollers each
• Automatic table thickness device

Specifications

• Working Unit
  • Motor Hp: 18 HP
  • Motor Type: Single Speed
  • Abrasive Belt Speed: 18 mps
  • Drum Size: 120 mm (4.75”)
  • Drum Type: 85 Sh Rubber
  • Platen Size: 50 mm (2”)
  • Platens Included: Two
  • Abrasive Belt Length: 60”
• Other Specs
  • Working Width: 950 mm (37”)
  • Number of Heads: Available 1
  • Feed Motor: .7 HP
  • Feed Speed: 15 or 30 fpm
  • Maximum Work piece Thickness: 160 mm (6.25”)
  • Minimum Work piece Length: 12.5 inches
  • Abrasive Belt Size: 37” X 60”
  • Compressed Air Requirements: 6 Bar (88 PSI.)
  • Dust Outlets: 1 outlets @ 140 mm (5.5”)
  • Exhaust Requirements: 900 CFM
  • Power Requirements: 54 amps @ 230 Volts/3 phase