Cantek 3HP 230V 2.25” Drawer Notcher JEN60

Adding undermount hardware to your cabinet drawers just got easier.

The Cantek JEN60 Drawer Notcher is designed to both notch and drill drawer boxes to install undermount soft-close drawer slides. The operation of the machine is simple with a self-indexing drilling unit that’s determined by the position of the drawer for either left or right notching. With a cycle time of approximately 10 seconds per drawer, you can achieve a high throughput and save time for other important tasks.

Why Cantek JEN60 Drawer Notcher?

• High production capacity of up to 220 drawers machined per hour.
• 57mm (2 ¼”) wide cutter head allows you to machine notches for a wide range of undermount drawer slides without needing to change heads or machine the component twice.
• Self-indexing drill unit for left or right drawer notching.
• Convenient foot pedal operation lets operator efficiently load and unload drawers for higher output.

Key Advantages

• Pneumatic cutter & drill stroke by foot pedal operation.
• Cutter stroke and drill speed are adjustable for optimum finish results
• Drill will automatically position for both left and right drawer notches by activating a switch in the fence
• Machine will not cycle unless a drawer is up against the switch for safe operation
• Insert knife cutterhead with solid carbide inserts for optimum finish results and long tool life
• 2 ¼” (57mm) wide cutter allows for a wide range of undermount slides
• Comes with insert cutterhead with inserts and ¼” (6.3mm) solid carbide drill bit.
• Capable of notching up to 220 drawer boxes (both left and right) per hour.

Features

• Drawer sample with left and right drawer notches
• Insert cutterhead remains below the table under a guard until in operation
• Simple drawer location stops and left and right limit switches for drill location
• 2.25” wide aluminum body insert knife cutterhead with replaceable carbide insert knives
• Convenient foot pedal operation
• Self-indexing drill unit

Specifications

• Main Cutter Motor: 3 HP
• Voltage: 230V
• Hz: 60
• Notch Dimensions: 2.25” (57mm) x 0.5” high
• Cutter Diameter: 10”
• Drill Diameter: 0.25”
• Table Size: 49” x 22”
• Table Height from Floor: 32”
• Dust Port: 2 x 4” (1,340 CFM Requirement)
• Compressed Air Required: 90-100 PSI
• Machine Dimensions: 49” x 37.75” x 39.75”
• Machine Weight: 506 lbs.